Email this article 
Influence of notch radius at advancing surface plastic deforming on endurance limit of detail
- Authors: Vakuljuk V.S.1, Kirpichyev V.A.1, Pavlov V.F.1, Chirkov A.V.1
-
Affiliations:
- Samara State Aerospace University named after academician S.P. Korolyov (National Research University)
- Issue: Vol 10, No 3-4 (2011): Special Issue
- Pages: 44-50
- Section: AIRCRAFT AND SPACE ROCKET ENGINEERING
- URL: https://journals.ssau.ru/vestnik/article/view/6929
- DOI: https://doi.org/10.18287/2541-7533-2011-0-3-4(27)-44-50
- ID: 6929
Cite item
Full Text
Abstract
It is experimentally established that with notch size increase at advancing surface plastic forming, the increment of an endurance limit in connection with reduction of compressing residual stresses in the minimal section of detail decreases.
About the authors
V. S. Vakuljuk
Samara State Aerospace University named after academician S.P. Korolyov (National Research University)
Author for correspondence.
Email: sopromat@ssau.ru
candidate of technical science, associate professor
Russian FederationV. A. Kirpichyev
Samara State Aerospace University named after academician S.P. Korolyov (National Research University)
Email: sopromat@ssau.ru
doctor of technical science, professor
Russian FederationV. F. Pavlov
Samara State Aerospace University named after academician S.P. Korolyov (National Research University)
Email: sopromat@ssau.ru
doctor of technical science, professor
Russian FederationA. V. Chirkov
Samara State Aerospace University named after academician S.P. Korolyov (National Research University)
Email: sopromat@ssau.ru
assistant
Russian FederationReferences
Supplementary files
