Email this article 
Sales training methods based on through the use of CAD / CAM / CAE systems for aero engines
- Authors: Balyakin A.V.1, Ermakov A.I.1, Pronichev N.D.1, Chempinsky L.A.1
-
Affiliations:
- Samara State Aerospace University named after academician S. P. Korolyov (National Research University)
- Issue: Vol 10, No 3-2 (2011): Special Issue
- Pages: 323-329
- Section: HUMANITIES
- URL: https://journals.ssau.ru/vestnik/article/view/6836
- DOI: https://doi.org/10.18287/2541-7533-2011-0-3-2(27)-323-329
- ID: 6836
Cite item
Full Text
Abstract
The article discusses the implementation of modern methods of training qualified specialists for the aircraft engine based on the through the use of CAD / CAM / CAE systems. In particular, sets out the stages of a geometric graphstudent training, engineering and technological design of aircraft engine parts
About the authors
A. V. Balyakin
Samara State Aerospace University named after academician S. P. Korolyov (National Research University)
Author for correspondence.
Email: a_balik@mail.ru
engineer Russian Federation
A. I. Ermakov
Samara State Aerospace University named after academician S. P. Korolyov (National Research University)
Email: fdla@ssau.ru
doctor of technical science, professor Russian Federation
N. D. Pronichev
Samara State Aerospace University named after academician S. P. Korolyov (National Research University)
Email: pdla@ssau.ru
doctor of technical science, professor Russian Federation
L. A. Chempinsky
Samara State Aerospace University named after academician S. P. Korolyov (National Research University)
Email: chempinskiy@mail.ru
candidate of technical science, professor Russian Federation
References
Supplementary files
