Research of technological heredity influence on setting of procedure of measurements on coordinate-measurement machine in case of out-of-flatness detecting for aircraft engineering parts

Abstract

This paper deals with out-of-flatness detection in case of control on CMM. As samples the flat surfaces after grinding, electrical discharge machining and milling are considered. The research of different machining on our-offlatness detecting results is done.

About the authors

A. O. Cheveleva

Samara State Aerospace University

Author for correspondence.
Email: Stasia-5@yandex.ru

Magister

Russian Federation

M. A. Bolotov

Samara State Aerospace University

Email: maikl_bol@rambler.ru

Engineer of the Aircraft Engine Production Department

Russian Federation

References

  1. Wilhelml R.G. Task Specific Uncertainty in Coordinate Measurement [Text] / R.G. Wilhelml, R. Hocken, H. Schwenke. – Elseiver, 2003. – Pp. 553–563.
  2. Maheshwari, N. On the selection of CMM based inspection methodology for circularity tolerances [Text] / N. Maheshwari. – Elseiver, 2001. – 58 Pp.
  3. Flack, D. CMM measurement strategies [Text] / D. Flack // NPL Measurment good practice guide. – 2001. – №41. – 99 Pp.
  4. Чевелева, А.О. Имитационные алгоритмы генерации разреженных выборок контролируемых точек при координатных измерениях [Текст] / А.О. Чевелева, М.А. Болотов // Региональная научно-практическая конференция, посвящѐнная 50-летию первого полѐта человека в космос. Самара, 14-15 апреля 2011 г.: тезисы докладов. – Самара: Издательство Самарского государственного аэрокосмического университета, 2011.− С. 145-146.
  5. Братухин, А. Г., Язов Г. К., Карасев Б. Е. и др. Современные технологии в производстве газотурбинных двигателей [Текст] / А.Г. Братухин, Г. К. Язов, Б. Е. Карасев и др.— М.: Машиностроение, 1977.

Statistics

Views

Abstract: 2806

PDF (Russian): 1758

Dimensions

PlumX

Refbacks

  • There are currently no refbacks.

Copyright (c) 2015 VESTNIK of the Samara State Aerospace University

This website uses cookies

You consent to our cookies if you continue to use our website.

About Cookies