Analysis of the stressed state of high-speed extrusion process

Abstract


The paper is devoted to the analysis of the stressed state of the process of high-speed extrusion. Factors that influence the stressed state at all stages of shape-forming are analyzed in detail. The influence of inertial forces on the force parameters of extrusion is discussed. The relationships required to determine power conditions of forming are given. Profound analysis of modeling the process of high-speed extrusion of a gas turbine engine compressor blade is carried out. The results of modeling confirm the theoretical conclusions.


About the authors

V. A. Kostyshev

Samara State Aerospace University

Author for correspondence.
Email: kostyshev@ssau.ru

Russian Federation

Doctor of Technical Science

Professor of the Department of Plastic Working of Metals

M. S. Pityugov

Samara State Aerospace University

Email: 123_456_789_1011@mail.ru

Russian Federation

Post-graduate Student of the Department of Plastic Working of Metals

References

  1. Согришин, Ю. П. Штамповка на высокоскоростных молотах [Текст] / Ю. П. Согришин, Л. Г. Гришин, В. М. Воробьев. - М.: Машиностроение, 1978. – C. 8.

Statistics

Views

Abstract - 45

PDF (Russian) - 22

Article Metrics

Metrics Loading ...

PlumX

Dimensions

Refbacks

  • There are currently no refbacks.

Copyright (c) 2015 VESTNIK of the Samara State Aerospace University

This website uses cookies

You consent to our cookies if you continue to use our website.

About Cookies