Theoretical basis of forming forging impellers of blade machines in multichannel stamps

Cover Page

Cite item

Full Text

Abstract

It is proposed the classifier of solid stamped impellers used in gas and hydraulic impeller machines produced by hoy (semi-hot) stamping, which were produced in aviation industry. Article recounts information about research and development of schemes and structures of the multisectional stamps, non-dismountable (tyre supported) and dismountable wheels after forming. Extruding insertions are being pulled from interblade channels. It is considered the principle of constructing theoretical cylindrical lattices of channels for multi-split stamps, due to which it is possible to calculate the forces of disclosure in stamps’ channels and rotational forces of the compound matrixes during extrusion.

About the authors

V. M. Vorobjev

Moscow Science and Technical Centre «AVERT»

Author for correspondence.
Email: avert_msk@mail.ru

Doctor of Technical Sciences, Professor

General Director

Russian Federation

References

  1. Воробьёв, В.М. Классификация цельноштампованных колёс лопаточных машин [Текст] / В.М. Воробьёв // Кузнечно-штамповочное производство. Обработка материалов давлением. - 2010. - №11. - С. 23-27.
  2. Воробьёв, В.М. Построение теоретических решёток каналов многоразъёмных штампов и расчёт действующих в них сил [Текст] / В.М. Воробьёв // Кузнечно-штамповочное производство. Обработка материалов давлением. - 2011. - №1.- С. 25–28.
  3. Воробьёв, В.М. Разработка схем и конструкций многоразъёмных штампов для производства точных заготовок с отростками [Текст] / В.М. Воробьёв // Заготовительные производства в машиностроении. - 2011. - №2. - С. 30–32.

Supplementary files

Supplementary Files
Action
1. JATS XML

Copyright (c) 2015 VESTNIK of the Samara State Aerospace University

This website uses cookies

You consent to our cookies if you continue to use our website.

About Cookies