Increase treatment high strength steels 30HGSN2FA based on a minimum of energy consumption
- Authors: Trusov V.N.1, Zakonov O.I.1, Shikin V.V.1
-
Affiliations:
- Samara State Technical University
- Issue: Vol 11, No 3-1 (2012): Special Issue
- Pages: 162-166
- Section: CONFERENCE MATERIALS
- URL: https://journals.ssau.ru/vestnik/article/view/2111
- DOI: https://doi.org/10.18287/2541-7533-2012-0-3-1(34)-162-166
- ID: 2111
Cite item
Full Text
Abstract
The research process of milling the steel. Influence of method milling on the cutting force. Effect of changes in the parameters of the cutting conditions on cutting force. The influence of the cutting on the roughness of the surface. The influence of the cutting on the specific energy consumption.
About the authors
V. N. Trusov
Samara State Technical University
Author for correspondence.
Email: isap@samgtu.ru
Doctor of Technical Sciences, Professor
Manager by a Department the «Instrumental Systems and Service of Cars»
Russian FederationO. I. Zakonov
Samara State Technical University
Email: o_z@bk.ru
Postgraduate Student of Department is the «Instrumental Systems and Service of Cars»
Russian FederationV. V. Shikin
Samara State Technical University
Email: Dm40@bk.ru
Postgraduate Student of Department is the «Instrumental Systems and Service of Cars»
Russian FederationReferences
- Локтев, Д.А. Тенденции в обработке резанием [Текст] / Д.А. Локтев // Комплект: ИТО. - 2003.- № 04.- С. 21-23.
- Спиридонов, А.А. Планирование эксперимента при исследовании технологических процессов [Текст] / А.А. Спиридонов. - М.: Машиностроение, 1981.– 184 с.