Email this article 
Method of producing thin-walled conical parts in a die with an elastic element
- Authors: Popov I.P.1, Nesterenko E.S.1, Zimarev M.V.1
-
Affiliations:
- Samara State Aerospace University
- Issue: Vol 11, No 1 (2012)
- Pages: 161-169
- Section: MECHANICAL ENGINEERING AND POWER ENGINEERING
- URL: https://journals.ssau.ru/vestnik/article/view/1943
- DOI: https://doi.org/10.18287/2541-7533-2012-0-1(32)-161-169
- ID: 1943
Cite item
Full Text
Abstract
A new way forming of thin-walled conical parts in a die with an elastic element is proposed. In this method, the conditions of formation are considerably facilitated due to eliminating the reactive tangential stresses on the surface of the contact of the part and the elastic element. That will make it possible: to increase the height of stamped parts, to prevent losses of stability of the stamped part, to increase the maximum coefficient of forming.
About the authors
I. P. Popov
Samara State Aerospace University
Author for correspondence.
Email: nesterenko77@mail.ru
Doctor of Technical Science
Professor of the Department of Plastic Working of Metals
Russian FederationE. S. Nesterenko
Samara State Aerospace University
Email: nesterenko77@mail.ru
Candidate of Technical Sciences
Associate Professor of the Department of Plastic Working of Metals
Russian FederationM. V. Zimarev
Samara State Aerospace University
Email: max.zim@mail.ru
Bachelor of Engineering and Technology in Metallurgy
Russian FederationReferences
- Пат. 1132407 СССР, МПК В21 Д22/28. Способ штамповки конусных деталей [Текст] / И. П. Попов, В. П. Чистяков, В. Д. Маслов, Г. А. Топоров, 1983.
- Сторожев, М. В. Теория обработки металлов давлением: учебник для вузов [Текст] / М. В. Сторожев, Е. А. Попов. – 4-е изд., переработ. и доп. – М.: Машиностроение, 1977. – 423 с.
- Семёнов, Е. И. Ковка и штамповка [Текст] / Е. И. Семёнов - М.: Машиностроение, 1987. - 544 с.
Supplementary files
