Automatization of creation vane models for CAE with PROFILER
- Authors: Shabliy L.S.1, Dmitrieva I.B.1, Popov G.M.1
-
Affiliations:
- Samara State Aerospace University
- Issue: Vol 11, No 5-1 (2012): Special Issue
- Pages: 208-214
- Section: CONFERENCE MATERIALS
- URL: https://journals.ssau.ru/vestnik/article/view/1867
- DOI: https://doi.org/10.18287/2541-7533-2012-0-5-1(36)-208-214
- ID: 1867
Cite item
Full Text
Abstract
Methodology of automotive creation of vane 3D-model for gas-dynamic analysis in NUMECA is seeing. Ways of solving different problems during this process is suggested.
Keywords
About the authors
L. S. Shabliy
Samara State Aerospace University
Author for correspondence.
Email: shelbi-gt500@mail.ru
Instructor of Aircraft Engines Theory Department
Russian FederationI. B. Dmitrieva
Samara State Aerospace University
Email: tdla@ssau.ru
Associate Professor of Aircraft Engines Theory Department
Russian FederationG. M. Popov
Samara State Aerospace University
Email: grishatty@mail.ru
Engineer
Russian FederationReferences
- Дмитриева, И.Б. Автоматизация создания объёмной модели пера лопатки в ANSYS TurboGrid на базе традиционного представления его геометрии [Текст] / И.Б. Дмитриева, Л.С. Шаблий // Вестник Самарского государственного аэрокосмического университета имени академика С.П. Королёва. – Самара, 2011. – №3 (27). Часть 3. – С. 106-111.
- Параметрические кривые и их растеризация [Электронный ресурс]: http://www.intuit.ru/department/graphics/rastrgraph/4/rastrgraph_4.html.