Email this article 
Method and technical tools of assessing the reliability of digital angle converters
- Authors: Grechishnikov V.M.1, Yudin A.A.1
-
Affiliations:
- Samara State Aerospace University named after academician S. P. Korolyov (National Research University)
- Issue: Vol 10, No 6 (2011)
- Pages: 186-194
- Section: ELECTRONICS, MEASURING EQUIPMENT, RADIO ENGINEERING AND COMMUNICATION
- URL: https://journals.ssau.ru/vestnik/article/view/7421
- DOI: https://doi.org/10.18287/2541-7533-2011-0-6(30)-186-194
- ID: 7421
Cite item
Full Text
Abstract
The paper presents a new method to control the reliability of conversion based on the formation of a difference signal of the converter being verified and the reference converter. The principles of producing reliability control devices on its basis are also discussed. It is shown that in all cases the reliability control error is determined by the weight of the least significant digit of the reference digital angle converter. The relation between the permissible control error, the reliability of the reference digital angle converter and the ratio of the number of digits of the reference converter and the one being verified is established.
About the authors
V. M. Grechishnikov
Samara State Aerospace University named after academician S. P. Korolyov (National Research University)
Author for correspondence.
Email: gv@ssau.ru
doctor of technical science, professor
head of the department of electrical engineering
A. A. Yudin
Samara State Aerospace University named after academician S. P. Korolyov (National Research University)
Email: vip_6k_bkl@mail.ru
post-graduate student of the department of electrical engineering
Russian FederationReferences
Supplementary files
