Development of the method of calculation and design stand installation for testingmodes wet cleaning duct GTE
- Authors: Silaev B.M.1, Malcev E.N.2
-
Affiliations:
- Samara State Aerospace University named after academician S.P. Korolyov (National Research University)
- JSC «KUZNETSOV»
- Issue: Vol 10, No 3-3 (2011): Special Issue
- Pages: 282-285
- Section: AIRCRAFT AND SPACE ROCKET ENGINEERING
- URL: https://journals.ssau.ru/vestnik/article/view/6893
- DOI: https://doi.org/10.18287/2541-7533-2011-0-3-3(27)-282-285
- ID: 6893
Cite item
Full Text
Abstract
Developed by the authors presented a constructive and small-sized circuit pneumohydraulic bench setup to enable a refinement of modes wet cleaning duct GTE factory terms instead of pilot tests of real engines. Relations are obtained that allow reasonably calculated to determine the necessary structural, geometric and kinematic parameters of the installation.
About the authors
B. M. Silaev
Samara State Aerospace University named after academician S.P. Korolyov (National Research University)
Author for correspondence.
Email: Malcev_e@rambler.ru
Doctor of Engineering Science, Professor
Russian FederationE. N. Malcev
JSC «KUZNETSOV»
Email: Malcev_e@rambler.ru
principial engineer
Russian Federation