Email this article 
Computer design of the gear cutting process using gear hob cutters
- Authors: Polyanskov Y.V.1, Gismetulin A.R.1, Nikolayev A.V.1, Gribovskaya K.V.1
-
Affiliations:
- Ulianovsk State University
- Issue: Vol 8, No 1 (2009)
- Pages: 188-196
- Section: CONTROL, COMPUTER SCIENCE AND INFORMATION SCIENCE
- URL: https://journals.ssau.ru/vestnik/article/view/649
- DOI: https://doi.org/10.18287/2541-7533-2009-0-1(17)-188-196
- ID: 649
Cite item
Full Text
Abstract
The paper is devoted to a new method of developing the process of obtaining gear wheels using models obtained in the CAD-systems. Three 3-D models are used in order to develop the process: the 3-D model of the basic worm, the machining process model and the resulting 3-D model of the gear wheel.
Keywords
About the authors
Yu. V. Polyanskov
Ulianovsk State University
Author for correspondence.
Email: vest@ssau.ru
Russian Federation
A. R. Gismetulin
Ulianovsk State University
Email: vest@ssau.ru
Russian Federation
A. V. Nikolayev
Ulianovsk State University
Email: vest@ssau.ru
Russian Federation
K. V. Gribovskaya
Ulianovsk State University
Email: vest@ssau.ru
Russian Federation
References
Supplementary files
