Development of the techical requrement forming and validation technique in the GTE through course computer designing

Abstract

Within the limits of the through course computer designing (TCCP) process of forming a technical requirement in conformity with standards occurs on a KiPDLA chair under direction of teachers. A «Technical requirement on GTE designing forming and validation» process is broken into subprocesses in which based upon initial a conceptual GTE model and then GTE block diagram are created, criteria of optimization are defined, and the constructive-power scheme of support arrangement is created. Working on «Technical requirement on GTE designing forming and validation» procedure the opportunity of creation of the information system intended for support of GTE designing processes, storing, searching and the retrospective analysis of the information at training the future designer is shown.

About the authors

M. Ye. Prodanov

Samara State Aerospace University

Author for correspondence.
Email: sadohina@ssau.ru
Russian Federation

A. Yu. Tsoy

Samara State Aerospace University

Email: sadohina@ssau.ru
Russian Federation

References

Statistics

Views

Abstract: 2655

PDF (Russian): 1548

Dimensions

PlumX

Refbacks

  • There are currently no refbacks.

Copyright (c) 2015 VESTNIK of the Samara State Aerospace University

This website uses cookies

You consent to our cookies if you continue to use our website.

About Cookies