Experimental research of the surface layer quality and cutting forces in flat grinding of the BT6 titanium alloy

Abstract

A set of mathematical models, finite-element models and empirical dependences is being developed. All of them require practical testing. The article presents the results of experimental research of the quality and characteristics of grinding specimens made of the BT6 titanium alloy widely used in aerospace industry.  Machining was conducted on a modern surface grinding machine, model 3D711VF11 by a ceramically bonded silicon carbide disk. The operation components of the cutting force, surface roughness (before and after machining of the specimens), as well as residual stresses were measured in the course of operation. All measurements were performed with the same specimens that were sequentially machined with the measurement of the earlier described parameters. In view of this, it is possible to trace all the transformations that take place inside the specimens. A force gage made jointly with the Department of Mechanical Engineering of SamGTU (Samara State Technical University) was used as a force-measuring system. The results of the research can be used to verify the adequacy of the mathematical models created and provide an insight into some processes occuring in surface grinding of flat titanium alloy blanks.

About the authors

D. G. Fedorov

Samara State Aerospace University

Author for correspondence.
Email: fedorovdmytry@gmail.ru

Engineer

Russian Federation

D. L. Skuratov

Samara State Aerospace University

Email: skuratov@ssau.ru

Doctor of Science (Engineering), Professor

Head of the Department of Engine Production Technology

Russian Federation

References

  1. Al'tman M.B., Glazunov S.G., Kishkina S.I. Aviatsionnye materialy. Т. 5 [Aircraft materials. Reference book in 9 volumes.V. 5]. Moscow: ONTI Publ., 1973. 583 p.
  2. Nenashev M.V., Kalashnikov V.V., Demoretskiy D.A., Ibatullin I.D., Nechaev I.V., Zhuravlev A.N., Murzin A.Yu., Ganigin S.Yu., Yakunin K.P., Kobyakina O.A., Chebo-taev A.A., Utyankin A.V., Shashkina T.A., Neyaglova R.R., Trofimova E.A., Gallyamov A.Kh. Ustroystvo dlya tribotekhnicheskikh ispytaniy materialov [Device for tribotechnical tests of materials]. Patent RF, no. 2011113074, 2012. (Published 10.10.2012, bulletin no. 28).
  3. Bukatyy S.A. Prognozirovanie korobleniya detaley GTD posle obrabotki poverkhnosti na osnove issledovaniya ostatochnogo napryazhennogo sostoyaniya materiala Dis. dokt. tekhn. nauk. [Predicting warpage of gas turbine engine components after surface treatment based on the research of the residual stress state of the material. Doctoral thesis in Engineering Science]. Rybinsk, 1996. 265 p.
  4. Kravchenko B.A., Kravchenko A.B. Fizicheskie aspekty teorii protsessa rezaniya metallov [Physical aspects of the theory of metal cutting]. Samara: Samara State Technical University Publ., 2002. 167 p.

Statistics

Views

Abstract: 3780

PDF (Russian): 1924

Dimensions

PlumX

Refbacks

  • There are currently no refbacks.

Copyright (c) 2016 VESTNIK of the Samara State Aerospace University

This website uses cookies

You consent to our cookies if you continue to use our website.

About Cookies