Model of the turboprop engine reduction gear tooth harmonic spectral component

The width of spectral components in rotary machines is determined by the frequency modulation of the carrier from the rotor speed deviation in the stationary operation mode. It was shown that, for the tooth spectral component, it is not enough to take into account this factor only. The analysis of publications and the studies performed show that it is also determined by the effect of many other factors: process-related ones (errors in manufacturing and assembly of gear wheels), operation mode parameters (rpm, temperature, transmitted load); design-related factors (flexibility of drive parts; modification of the tooth face), as well as uneven wear of tooth flanks. Using the planetary gearbox of a turboprop engine as an example, the structure of the tooth spectral component width in function of the analyzed influencing factors was considered. Based on the vibration statistics for eighteen gearboxes in overhauled engines, the choice of a ratio for the spectral component width of a frequency modulated process was justified. This choice showed readings closest to the corresponding experimental data. For the vibration of ten gearboxes with different degrees of tooth flank wear, the corresponding dependence of the width on the wear is presented. A mathematical model for the tooth spectral component width in overhauled and newly manufactured gearboxes as the product of the constant coefficient with the deviation dispersion sum from the considered factors was proposed. The same dependence was also given for gearboxes with wear when adding the dispersion from wear to the dispersion sum. It was demonstrated that, for the presented case of the maximum wear, its fraction in the total width was about 50%, whereas the fraction of the frequency modulation from the operating system of adjusting relative rotor speed constancy in the stationary engine operation mode was equal to half of all the other factors.