Modeling of the soldering process for components of radio-electronic units of on-board equipment

  • Authors: Tyulevim S.1
  • Affiliations:
    1. Самарский национальный исследовательский университет им. акад. С.П. Королева
  • Issue: Vol 20, No 4 (2017)
  • Pages: 40-45
  • Section: Articles
  • URL: https://journals.ssau.ru/pwp/article/view/7072
  • ID: 7072

Cite item

Full Text

Abstract

The technological route for the production of radio electronic printed units is considered. Determined that he most critical operation is reflow soldering in the vapor-gas phase. The most significant factors of this operation are revealed by the method of expert evaluation. To construct a mathematical model a fractional factor experiment was carried out. The regression equation is obtained and carried out its verification for adequacy. A motion was made along the response surface in the direction of the gradient of the linear approximation until the area of the extremum was reached. In this case, an increase in the quality criterion has been achieved.

About the authors

S.V. Tyulevim

Самарский национальный исследовательский университет им. акад. С.П. Королева

Author for correspondence.
Email: kipres@ssau.ru

References

Supplementary files

Supplementary Files
Action
1. JATS XML

Copyright (c) 2017 Tyulevim S.

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.

СМИ зарегистрировано Федеральной службой по надзору в сфере связи, информационных технологий и массовых коммуникаций (Роскомнадзор).
Регистрационный номер и дата принятия решения о регистрации СМИ: серия ФС 77 - 68199 от 27.12.2016.

This website uses cookies

You consent to our cookies if you continue to use our website.

About Cookies