Numerical simulation of gas temperature spatial distribution in a one-burner sector of a gas turbine combustor with uncertain initial conditions of fuel atomization

Cover Page

Cite item

Full Text

Abstract

The influence of the initial conditions used when modeling atomized fuel on the accuracy of gas temperature field non-uniformity at the exit of a helicopter gas turbine annular reverse-flow combustor is analyzed. The analysis is based on the numerical solution of the problem of a three-dimensional two-phase flow with combustion. Computations for four models of fuel droplet feed are based on the integration of Reynolds equations for the gas phase and Lagrange equations for the fuel droplets. The influence of the initial conditions on the combustor exit gas temperature field non-uniformity is found to be insignificant. The comparison of the numerical results with the test data showed their better agreement for radial rather than circumferential nonuniformity.

About the authors

V. Ye. Kostyuk

National Aerospace University – Kharkiv Aviation Institute (KhAI)

Author for correspondence.
Email: kostyuk.v@mail.ru

Candidate of Technical Science

Senior Researcher

Ukraine

Ye. I. Kirilash

National Aerospace University – Kharkiv Aviation Institute (KhAI)

Email: kirilashelena@rambler.ru

Research Assistant

Ukraine

A. V. Stasyuk

«Motor Sich» plc, Zaporozhye

Email: kb-5.ugk@motorsich.com

Head of the Combustion Chambers Department

Ukraine

V. V. Shein

«Motor Sich» plc, Zaporozhye

Email: kb-5.ugk@motorsich.com

Head of Design- and-experimental Group of the Combustion Chambers Department

Ukraine

D. V. Karzov

«Motor Sich» plc, Zaporozhye

Email: kb-5.ugk@motorsich.com

Engineer of the Combustion Chambers Department

Ukraine

References

  1. Аэродинамический расчёт и оптимальное проектирование проточной части турбомашин [Текст] / А.В. Бойко, Ю.Н. Говорущенко, С.В. Ершов [и др.] – Харьков: НТУ «ХПИ», 2002. – 356 с.
  2. Куценко, Ю.Г. Численные методы оценки эмиссионных характеристик камер сгорания газотурбинных двигателей [Текст] / Ю.Г. Куценко. – Екатеринбург-Пермь: УрО РАН, 2006. – 140 с.
  3. CFD Modeling of the Aero Gas Turbine Combustor [Text] / G. Sivaramakrishna, Sh. Venkataraman, N. Muthuveerappan, T.K. Sampathkumaran // Proceedings of ASME TURBO EXPO 2001: June 4-7, 2001, New Orleans, Louisiana (2001-GT-0063). – 6 pp.
  4. Large Eddy Simulation of Two-Phase Reacting Flows [Text] / B. Cueno, M. Boileau, S. Pascaudy etc. // European Conference on Computational Fluid Dynamics ECCOMAS CFD 2006, TU Delft, Netherlands, 2006. – 19 рр.
  5. Van Niekerk, J.E. Prediction of the T56 Turbine Inlet Temperature Profile with an Abnormal Fuel Distribution [Text] / J.E. van Niekerk, C.J. Meyer, R.M. Morris // Papers of XVII International Symposium on Air Breathing Engines (XVII ISABE). September 4-9, 2005, Munich, Germany (ISABE-2005-1229). – 11 pp.
  6. Application Of An Advanced CFDBased Analysis System to the PW6000 Combustor to Optimize Exit Temperature Distribution – Part I: Description and Validation of the Analysis Tool [Text] / R.E. Malecki, Ch.M. Rhie, R.G. McKinney, etc. // Proceedings of ASME TurboExpo 2001. June 4-7, 2001, New Orleans, Louisiana (2001-GT-0062). – 9 pp.
  7. A New Paradigm for Simulation of Turbulent Combustion in Realistic Gas Turbine Combustors Using LES [Text] / G. Constantinescu, K. Mahesh, S. Apte, etc. // Proceedings of ASME Turbo Expo 2003. June 16-19, 2003, Atlanta, Georgia, USA (GT2003-38356). – 14 pp.
  8. Сербин, С.И. Моделирование процесса распыливания жидкого топлива центробежной форсункой [Текст] / С.И. Сербин, С.В. Вилкул // Авиационно-космическая техника и технология. – 2008. – № 7. – С. 95 – 99.

Supplementary files

Supplementary Files
Action
1. JATS XML

Copyright (c) 2015 VESTNIK of the Samara State Aerospace University

This website uses cookies

You consent to our cookies if you continue to use our website.

About Cookies