Influence of asymmetrical initial form imperfections on fre oscillations of thin shells


Cite item

Full Text

Abstract

In the framework of the theory of shallow shells we studied the effect of the initial deviations from the ideal circular cylindrical shape on flexural vibrations of thin isotropic shells. For the first time the possibility of an additional zone of splitting the flexural frequency spectrum due to the presence of initial shell form imperfections is shown in the paper. It is found that the splitting of the frequency spectrum occurs not only in cases when the number of waves of circumferential dynamic strain is equal to the number of waves of shell form imperfections  as generally agreed at present, but also in cases when the number of shape-generating waves is half that of wave imperfections. In the first case, both the split frequencies are lower than the corresponding frequency of the ideal shell. It was established that for some geometrical parameters of the shell the frequencies of radial vibrations may be commensurate with the flexural ones.  Solutions that take into account the interaction of bending and radial mode shapes are complemented with new results and conclusions. It was concluded that under the influence of periodic loads that inevitably arise in the operating conditions of shell structures, non-resonant zones defned according to the traditional approach can, in fact, be resonant. Resonance hazardous vibration conditions of shell structures with irregularities of this kind can occur at frequencies much lower or higher than the traditional theory predicted. This behavior of imperfect shells may lead to high stress-strain state of the structure and complex types of dynamic instability under operating conditions. The results and conclusions obtained in this work call for the revision of problems of the dynamics of shells with form imperfections that were solved earlier.

About the authors

S. V. Seregin

Komsomolsk-na-Amure State Technical University

Author for correspondence.
Email: Seregin-komsHome@yandex.ru

Candidate of Science (Engineering)
Senior Research Associate, Research Management Department

Russian Federation

References

  1. Kuznetsov A.P., Kuznetsov S.P. Nonlinear oscillations, catastrophe, bifurcation, chaos. Izvestiya VUZ. Applied Nonlinear Dynamics. 2013. V. 21, no. 3. P. 1-10. (In Russ.)
  2. Anisimov M.K., Ponikarov S.I., Cherenkov A.V. Numerical analysis of the stability of cylindrical shells loaded with axial compressive force, taking into account the geometric imperfections. Mechanical Engineering and Engineering Education. 2006. No. 4. P. 49-56. (In Russ.)
  3. Begichev M.M. Chislennyy analiz ustoychivosti sterzhnevykh sistem i obolochek pri uprugikh i plasticheskikh deformatsiyakh s uchetom nachal'nykh nesovershenstv. Avtoreferat dis. kand. tekhnicheskikh nauk [Numerical analysis of stability of frame structures and shells under elastic and plastic deformations with account for initial imperfections. Extended abstract of Cand. Sci. (Eng.) Diss.]. Moscow, 2013. 24 p.
  4. Lopanitsyn E.A., Matveev E.A. Stability of cylindrical shells with initial imperfections under the action of external pressure. Mechanics of Solids. 2011. V. 46, Iss. 2. P. 170-178. doi: 10.3103/s0025654411020038
  5. Olevs'kyy V.I., Mil'tsyn A.M., Pletin V.V. Multifactorial study of the stability of thin-walled shells with imperfections. Vestnik of Lobachevsky University of Nizhni Novgorod. 2011. No. 4 (4). P. 1663-1665. (In Russ.)
  6. Efremova G.I. Defining stressed & strained state of stiffened cylindrical shells with initial bending of arbitrary shape. Proceedings of the Krylov State Research Centre. 2009. No. 42. P. 19-26. (In Russ.)
  7. Popov O.N., Moiseenko M.O., Treputneva T.A. Influence of symmetric general initial flexure on mode of deformation and stability of flat cylindrical shells. Structural Mechanics and Analysis of Constructions. 2010. No. 4. P. 34-39. (In Russ.)
  8. Tovstik P.E., Chernjaev S.P. Nonlinear deformation of thin shells with the middle surface imperfections. Vestnik Sankt-Peterburgskogo Universiteta. Ser. 1. Matematika, Mekhanika, Astronomiya. 2004. No. 3. P. 88-95. (In Russ.)
  9. Varyanichko M.A., Karasev A.G., Lykhachova O.V., Krasovsky V.L. The influence of the initial imperfections of geometry on the critical pressure of the closed elastic plain flatsloped conical shells. Bulletin of Prydniprovs’ka State Academy of Civil Engineering and Architecture. 2010. No. 6 (147). P. 20-31. (In Russ.)
  10. Lopashev P.A. Method for automatic account of geometric shape defects for cylinder shells in FEM analysis of bearing capacity. Proceedings of the Krylov State Research Centre. 2009. No. 46. P. 173-180. (In Russ.)
  11. Lukin Ya.A., Efimenko E.S. Optimization of bearing systems of all-metal bodies of cars such as the closed shell taking into account the initial imperfections. Vestnik Rostovskogo Gosudarstvennogo Universiteta Putey Soobshcheniya. 2008. No. 1 (29). P. 9-13. (In Russ.)
  12. Mamai V.I. Load-carrying capacity of thin-walled shells with local imperfections. Mechanics of Solids. 2011. V. 46, Iss. 2. P. 179-173. doi: 10.3103/S002565441102004X
  13. Korotkov A.V., Kulikov Yu.A. Forced Parametric Vibration of Curved Composite Pipes with Initial Technological Imperfections. Mekhanika kompozitsionnykh materialov i konstruktsii. 2014. V. 20, no. 1. P. 16-33. (In Russ.)
  14. Miltsin A.M., Olevsky V.I., Pletin V.V. On the forms of buckling waves of non uniformly loaded cylindrical shells with technological imperfections. Eastern-European Journal of Enterprise Technologies. 2011. V. 5, no. 7 (53). P. 44-48. (In Russ.)
  15. Snisarenko S.I., Hvaskov B.E. Dynamic deformation of cylindrical composite membranes with structural and technological defects. Scientific Bulletin of NSTU. 2009. No. 3. P. 115-120. (In Russ.)
  16. Moiseenko M.O., Pestsov D.N., Popov O.N., Treputneva T.A. Obzor rabot po raschetu plastin i obolochek s malymi nachal'nymi nesovershenstvami formy sredinnoy poverkhnosti: deponirovannaya rukopis' [A review of studies on the calculation of plates and shells with small initial imperfections of the middle surface]. Deposited manuscript № 501-В2011; 22.11.2011. 28 p.
  17. Taranukha N.A., Leizerovich G.S. Dinamika «nepravil'nykh» obolochek [Dynamics of irregular shells]. Vladivostok: Dal'nauka Publ., 2005. 422 p.
  18. Amabili M. Nonlinear vibrations and stability of shells and plates. New York: Cambridge University Press, 2008. 392 p.
  19. Kubenko V.D., Koval'chuk P.S., Krasnopol'skaya T.S. Nelineynoe vzaimodeystvie form izgibnykh kolebaniy tsilindricheskikh obolochek [Nonlinear interaction of forms of flexural vibrations of cylindrical shells]. Kiev: Naukova Dumka Publ., 1984. 220 p.
  20. Varadan T. K., Pratkhap Dzh., Ramani Kh.V. Nonlinear free bending vibrations of thin-walled circular cylindrical shells. Aerokosmicheskaya tekhnika. 1990. No. 5. P. 21-24. (In Russ.)
  21. Seregin S.V., Leizerovich G.S. Free vibration of infinite length circular cylindrical shell with initial imperfections and a small added mass. Scholarly Notes of Komsomolsk-na-Amure State Technical University. 2014. V. 1, no. 4 (20). P. 36-43. (In Russ.)
  22. Lejzerovich G.S., Prihod’ko N.B., Seregin S.V. Influence of low additional mass on splitting of the frequency spectrum of a circular ring with initial irregularities. Structural Mechanics and Analysis of Constructions. 2013. No. 6. P. 49-51. (In Russ.)
  23. Lejzerovich G., Prihod'ko N., Serjogin S. On the influence of small additional masson vibration of a ring with different thicknesses. Building and Reconstruction. 2013. No. 4. P. 38-42. (In Russ.)
  24. Seregin S.V. Free flexural radial vibrations of a thin circular cylindrical shell bearing added mass. Vestnik MGSU. 2014. No. 11. P. 74-81. (In Russ.)
  25. Seregin S.V. Numerical and analytical investigation of free vibrations of circular cylindrical shells with added mass linearly distributed along generatrix. Computational Continuum Mechanics. 2014. V. 7, no. 4. P. 378-384. (In Russ.)
  26. Seregin S.V. Free vibrations of a thin circular cylindrical shell weakened by a hole. Russian Aeronautics. 2015. V. 58, Iss. 3. P. 258-262. doi: 10.3103/S1068799815030022
  27. Seregin S.V. Influence of the contact area and value of the linearly distributed and concentrated mass with a circular cylindrical shell on the frequency and modes of natural oscillations. Vestnik MGSU. 2014. No. 7. P. 64-74. (In Russ.)
  28. Seregin S.V. Regarding the splitting of the frequency spectrum of the bending of thin circular cylindrical shells carrying the associated mass. Structural Mechanics and Analysis of Constructions. 2014. No. 6 (257). P. 59-61. (In Russ.)
  29. Seregin S.V., Leizerovich G.S. Influence of the added mass on the dynamic characteristics of thin shells. Engineering and Automation Problems. 2015. No. 4. P. 83-89. (In Russ.)
  30. Seregin S.V. Investigation of dynamic characteristics of shells with holes and added mass. Vestnik MGSU. 2014. No. 4. P. 52-58. (In Russ.)
  31. Seregin S.V. The influence attached body on the frequency and forms free vibrations cylindrical shells. Structural Mechanics and Analysis of Constructions. 2014. No. 3 (254). P. 35-38. (In Russ.)
  32. Vol'mir A.S. Nelineynaya dinamika plastinok i obolochek [Nonlinear dynamics of plates and shells]. Moscow: Nauka Publ., 1972. 432 p.
  33. Grishin N.F. Svobodnye kolebaniya tsilindricheskikh obolochek, imeyushchikh nachal'nuyu pogib'. V kn.: Dinamika sudovykh obolochek (Materialy po obmenu opytom). Iss. 208. Leningrad: Sudostroenie Publ., 1974. P. 31-40. (In Russ.)
  34. Seregin S.V. Dinamika tonkikh tsilindricheskikh obolochek s prisoedinennoy massoy [Dynamics of thin cylindrical shells with added mass]. Komsomolsk-on-Amur: Komsomolsk-na-Amure State Technical University Publ., 2016. 175 p.

Supplementary files

Supplementary Files
Action
1. JATS XML

Copyright (c) 2017 VESTNIK of Samara University. Aerospace and Mechanical Engineering

This website uses cookies

You consent to our cookies if you continue to use our website.

About Cookies