Methodology of designing a space transport system including a “DM” chemical upper stage and an electric rocket transport module


Cite item

Abstract

The article is devoted to the development of a methodology for designing a space transport system that has, in comparison with traditional injection scenarios, higher characteristics of the mass of the payload to be launched into high-energy orbits, including a geostationary one. The method is implemented by the systematization of design calculations and proposals for the rational design of interorbital vehicles with a combined propulsion system and the development of an algorithm for creating an electronic model of an interorbital vehicle in an automated designing PTC Creo system. The article considers algorithms for calculating the design parameters of the electric rocket transport module and ballistic parameters of the spacecraft flight to the target orbit. A method of forming conceptual design of an electric rocket transport module based on the obtained design parameters is also proposed. An electronic model of an electric rocket module was developed in a three-dimensional modeling system. The model displays the structural design of the module in accordance with the design parameters obtained and satisfies the design requirements imposed by other components of the space transport system. The proposed method makes it possible to design a space transport system that includes a DM upper stage and an electric rocket transport module designed to implement a combined payload injection scenario.

About the authors

A. S. Russkikh

S.P. Korolyov Rocket and Space Corporation “Energia”

Author for correspondence.
Email: anton.russkikh@rsce.ru

Head of Department

Russian Federation

V. V. Salmin

Samara National Research University

Email: sputnik@ssau.ru

Doctor of Science (Engineering), Full Professor, Director of the Research Institute of Space Engineering

Russian Federation

References

  1. Zakharov A. Kosmodromy – «klyuch na start» [Cosmodromes – «the key to start»]. Available at: https://www.vokrugsveta.ru/vs/article/2902/
  2. Petrukhina K.V., Salmin V.V. Optimization of flights ballistic schemes between non-coplanar orbits by means of the combination of high and low thrust engines. Izvestiya Samarskogo Nauchnogo Tsentra RAN. 2010. V. 12, no. 4. P. 186-201. (In Russ.)
  3. Filatov A.N. Razrabotka metodov i modeley parallel'nogo niskhodyashchego proektirovaniya raketno-kosmicheskoy tekhniki v edinom informatsionnom prostranstve predpriyatiya. Avtoref. dis. ... kand. tekhn. nauk [Development of methods and models of parallel top-down design of rocket and space equipment in the single information space of an enterprise: Extended abstract of dissertation Candidate of Science (Engineering)]. Samara, 2014. 16 p.
  4. Salmin V.V., Kvetkin A.A., Russkikh A.S. Choice of mission trajectory plans and conceptual design of electrical propulsion module for launching payloads into circumterrestrial orbits. Vestnik of Samara University. Aerospace and Mechanical Engineering. 2020. V. 19, no. 4. P. 58-69. (In Russ.). doi: 10.18287/2541-7533-2020-19-4-58-69

Copyright (c) 2023 VESTNIK of Samara University. Aerospace and Mechanical Engineering

Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

This website uses cookies

You consent to our cookies if you continue to use our website.

About Cookies