Choosing the optimal method of the centrifugal loads modeling using 2D FE models of the compressor’s disks slots

Abstract


Choosing the optimal method of the centrifugal loads of the LPC and HPC blades is the one most actual problem in 2D FE modeling. There are some methods of the centrifugal loads simulations. This issue is relevant for the most accurate simulations of the centrifugal loads on the HPT and LPT disks. According to the results the most accurate method is chosen.


About the authors

N. N. Balyaeva

A. Lyulka Scientific and Technical Center, Moscow

Author for correspondence.
Email: NNBalyaeva@gmail.com

Russian Federation

Design Engineer

A. Y. Guschin

A. Lyulka Scientific and Technical Center, Moscow

Email: NNBalyaeva@gmail.com

Russian Federation

Candidate of Technical Science

Design Engineer

References

  1. Обоснование банка данных по основным характеристикам прочности, используемым в САПР турбины и компрессора ГТД [Текст]: науч.-техн. отчёт / Р.Н. Сизова, Ж.А. Бычкова, Е.Н. Богачева [и др.] – М.: ЦИАМ, 1986. – 117 с.
  2. Авиационные материалы [Текст]: справочник в 9 т. Т. 5: Магниевые и титановые сплавы / под общ. ред. А.Т. Туманова. – М.: ОНТИ, 1973. – 583 с.
  3. Биргер, И.А. Расчёт на прочность деталей машин [Текст]: справочник / И.А. Биргер, Б.Ф. Шорр, Г.Б. Иосилевич. – М.: Машиностроение, 1993. – 640 с.

Statistics

Views

Abstract - 29

PDF (Russian) - 9

Article Metrics

Metrics Loading ...

PlumX

Dimensions

Refbacks

  • There are currently no refbacks.

Copyright (c) 2015 VESTNIK of the Samara State Aerospace University

This website uses cookies

You consent to our cookies if you continue to use our website.

About Cookies