Email this article 
Methods of increase of wear resistance and vibroakusticheskikh of parameters of knots of the friction of space equipment
- Authors: Gromakovsky D.G.1, Kovshov A.G.1, Kotcherov E.P.2, Makaryants M.V.3
-
Affiliations:
- Samara State Technical University
- JSC "Kuznetsov", Samara
- "SSDB-Progress", Samara
- Issue: Vol 11, No 3-1 (2012): Special Issue
- Pages: 26-32
- Section: CONFERENCE MATERIALS
- URL: https://journals.ssau.ru/vestnik/article/view/2090
- DOI: https://doi.org/10.18287/2541-7533-2012-0-3-1(34)-26-32
- ID: 2090
Cite item
Full Text
Abstract
The ways providing simultaneous increase of wear resistance, decrease in noise level and the vibration generated in knots of a friction are considered. The offered technologies are connected with formation containing fluorine the microdimensional films raising wear resistance, contact weariness and durability of connection of a lubricant layer with friction surfaces; the microreinforcing of superficial defects which is slowing down development of fatigue damages; the effect of multigreasing raising loading characteristics of a lubricant layer and its absorbing ability.
About the authors
D. G. Gromakovsky
Samara State Technical University
Author for correspondence.
Email: pnms3@mail.ru
Doctor of Technical Science, Professor
Director of Scientific and Technological Center "Reliability"
Russian FederationA. G. Kovshov
Samara State Technical University
Email: pnms3@mail.ru
Candidate of Technical Science
Associate Professor of a Nanotechnology in Mechanical Engineering
Russian FederationE. P. Kotcherov
JSC "Kuznetsov", Samara
Email: kotcherov_ep@motor-s.ru
Candidate of Technical Science
First Deputy General Designer
Russian FederationM. V. Makaryants
"SSDB-Progress", Samara
Email: csdb@mail.samtel.ru
Deputy Chief Designer, Chief of Office
Russian FederationReferences
- Громаковский, Д.Г. Проблемы разработки термофлуктуационной модели изнашивания поверхности [Текст] / Д.Г. Громаковский, Б.М. Силаев, Л.М. Логвинов. // Трение и смазка в машинах и механизмах. -2009. -№6. – C. 45-48.
- Современные технологии и долговечность поверхностей трения при усталостном механизме изнашивания [Текст] / Д.Г. Громаковский, В.А. Горохов, Г.А. Кулаков [и др.] // Трение и смазка в машинах и механизмах. 2006. - №3. – С. 11-20.
- А.с. 1309666. Способ получения антифрикционного покрытия на рабочих поверхностях деталей в узлах трения машин [Текст] / Д.Г. Громаковский, Н.Г. Макаров, Н.Д. Кузнецов [и др.]. - опубл. 08.01.87.
- Пат. № 2198954. Способ упрочнения поверхности деталей [Текст] / Д.Г. Громаковский, А.Г. Ковшов, С.В. Шигин [и др.]. - опубл. 20.02.2003, Бюл. №5.
- Пат. №2334909. Способ смазки узлов трения [Текст] / Д.Г. Громаковский, В.А. Николаев, В.И. Хаустов [и др.]. – опубл. 27.09.2008, Бюл. №27.
Supplementary files
