Email this article 
Choosing the optimal method of the centrifugal loads modeling using 2D FE models of the compressor’s disks slots
- Authors: Balyaeva N.N.1, Guschin A.Y.1
-
Affiliations:
- A. Lyulka Scientific and Technical Center, Moscow
- Issue: Vol 11, No 3-2 (2012): Special Issue
- Pages: 117-124
- Section: CONFERENCE MATERIALS
- URL: https://journals.ssau.ru/vestnik/article/view/2161
- DOI: https://doi.org/10.18287/2541-7533-2012-0-3-2(34)-117-124
- ID: 2161
Cite item
Full Text
Abstract
Choosing the optimal method of the centrifugal loads of the LPC and HPC blades is the one most actual problem in 2D FE modeling. There are some methods of the centrifugal loads simulations. This issue is relevant for the most accurate simulations of the centrifugal loads on the HPT and LPT disks. According to the results the most accurate method is chosen.
About the authors
N. N. Balyaeva
A. Lyulka Scientific and Technical Center, Moscow
Author for correspondence.
Email: NNBalyaeva@gmail.com
Design Engineer
Russian FederationA. Y. Guschin
A. Lyulka Scientific and Technical Center, Moscow
Email: NNBalyaeva@gmail.com
Candidate of Technical Science
Design Engineer
Russian FederationReferences
- Обоснование банка данных по основным характеристикам прочности, используемым в САПР турбины и компрессора ГТД [Текст]: науч.-техн. отчёт / Р.Н. Сизова, Ж.А. Бычкова, Е.Н. Богачева [и др.] – М.: ЦИАМ, 1986. – 117 с.
- Авиационные материалы [Текст]: справочник в 9 т. Т. 5: Магниевые и титановые сплавы / под общ. ред. А.Т. Туманова. – М.: ОНТИ, 1973. – 583 с.
- Биргер, И.А. Расчёт на прочность деталей машин [Текст]: справочник / И.А. Биргер, Б.Ф. Шорр, Г.Б. Иосилевич. – М.: Машиностроение, 1993. – 640 с.
Supplementary files
