Email this article 
Analysis of models of fuel elements while using of surface mountng
- Authors: Knyazeva G.N.1, Krasnoshchekova G.F.1, Tyulevin S.V.1
-
Affiliations:
- Samara State Aerospace University
- Issue: Vol 11, No 7 (2012)
- Pages: 152-155
- Section: ISSUE WITHOUT SECTION
- URL: https://journals.ssau.ru/vestnik/article/view/2407
- DOI: https://doi.org/10.18287/2541-7533-2012-0-7(38)-152-155
- ID: 2407
Cite item
Full Text
Abstract
This paper presents the thermal models of different fuel components that are attached in various ways to the board and calculations of their heat resistance are given below. Also in the analysis of the thermal resistances a great attention is given to the calculation of the thickness of thermal paste. It is shown that the thickness of the paste layer depends on the gap between the contacting surfaces.
About the authors
G. N. Knyazeva
Samara State Aerospace University
Email: kipres@ssau.ru
Under-graduate Student of Design and Production Radioelectronic Means
Russian FederationG. F. Krasnoshchekova
Samara State Aerospace University
Author for correspondence.
Email: kipres@ssau.ru
Candidate of Technical Sciences
Assistant Professor of Design and Production Radio-electronic Means
Russian FederationS. V. Tyulevin
Samara State Aerospace University
Email: kipres@ssau.ru
Candidate of Technical Sciences
Assistant Professor of Design and Production Radio-electronic Means
Russian FederationReferences
- Зеленский, А.В. Электронные средства. Конструкции и расчетные модели: учебное пособие [Текст] / А.В. Зеленский, Г.Ф. Краснощекова. – Самара: Изд-во СГАУ, 2010. – 152 с.
- Медведев, А.М. Сборка и монтаж электронной аппаратуры [Текст] / А.М. Медведев. – М.: Техносфера, 2007. – 208 с.
Supplementary files
